Požiadavky na vnútornú inštaláciu sledovacích kamier

Dec 12, 2021

Zanechajte správu

1. When wiring the surveillance camera, try to avoid any joints in the wires. Unless it is impossible to use a connector, the connector of the camera must be crimped or welded, and the wire connection and branch should not be subjected to mechanical force. The wires that are empty in the pipe should not have connectors under any circumstances. If necessary, put the connectors on the probe terminal of the junction box as much as possible.

2. The rated voltage of the wire used for surveillance cameras should be greater than the working voltage of the circuit; the insulation of the wire should conform to the installation method of the circuit and the environmental conditions for laying. The cross-sectional area of the wire should be able to meet the requirements of power supply and mechanical strength.

3. The wiring of the surveillance camera should be installed horizontally or vertically in the building. The wiring should be protected by sleeves (plastic or iron water pipes, optional according to the technical requirements of indoor piping), and metal hoses can be used for ceiling wiring, but they need to be fixed and secure.

Fourth, the signal line of the surveillance camera cannot be parallel to the high-power power line, let alone wear it in the same tube. If due to environmental constraints, the wires should be routed in parallel, and the distance should be more than 50cm.

5. AC napájanie riadiacej skrinky kamerového alarmu by malo byť vedené oddelene. Kamera by nemala byť umiestnená v rovnakej trubici so signálnym vedením a nízkonapäťovým jednosmerným vedením. Inštalácia striedavého elektrického vedenia by mala zodpovedať normám elektrickej inštalácie.

6. Existujú dva typy káblov a trubicových káblov pre monitorovacie kamery: svetlá konfigurácia a tmavá konfigurácia. Potrubie kamery musí byť horizontálne a vertikálne, elegantné a krásne. Skryté potrubie vyžaduje krátke, voľné a málo lakťov.

7. Vyžaduje sa, aby kabeláž od poplachovej riadiacej skrinky monitorovacej kamery po strop bola vedená v stene alebo chránená železnými rúrami, aby sa zlepšila antideštruktívna účinnosť systému ochrany proti krádeži. Technické požiadavky na vnútorné potrubie kamery

Zaslať požiadavku